4-Channel Digital Video Recorder
51
Full Screen
2x2
Previous Camera
Next Camera
OSD
Figure 54 Mouse Display menu.
Full Screen
Selecting (Full Screen) in the Mouse Display menu and choosing the camera number button
displays the selected camera full screen. It is the same as pressing the individual camera buttons
on the front panel.
2x2
Selecting (2x2) in the Mouse Display menu displays the cameras in the quad (2x2) screen mode.
It is the same as pressing the individual camera buttons or the
LAYOUT button on the remote
control in the full screen mode.
Previous Camera, Next Camera
Selecting or (Previous Camera or Next Camera) in the Mouse Display menu moves to the
previous or next camera.
OSD
Selecting (OSD) in the Mouse Display menu toggles OSD On and Off.
Recording Video
Once you have installed the DVR following the instructions in Chapter 2 Installation, it is ready
to record. The DVR will start recording based on the settings you made in the Record setup screen.
See Chapter3 Configuration.
Recycle On or Recycle Off. The factory default is Recycle On. It does this by recording over
the oldest video once the hard disk is full. Setting the DVR to Recycle Off causes it to stop recording
once the hard disk is full.
Pressing the PANIC button starts panic recording of all cameras, and pressing the button again stops
panic recording. If you set the Panic Recording Duration in the Record Screen, panic recording
will stop automatically according to the preset duration as long as the
PANIC button is not pressed.
To Next Page
Loading...
Need help?
General
