User’s Manual
46
NOTE: For the Notify action to work, the DVR should be registered in the RAS (Remote
Administration System).
Event Status
Highlight Event Status in the Event menu and press the button. The Event Status setup screen
appears.
Check Alarm-In and Check Recording will be highlighted when each event is detected based
on the settings you made in the System Event setup screen on the Event menu.
Panic Record will be highlighted while the DVR is in the panic recording mode.
Disk Almost Full will be highlighted when the DVR is not in the Recycle mode and the level of
disk usage reaches the Disk Almost Full percentage you made in the System Event setup screen
on the Event menu. Disk Full will be highlighted when the DVR is not in the Recycle mode and
all available storage space has been used. Disk Config Change will be highlighted when the
DVR reboots after the hard disk drive has been replaced.
Highlighting the Storage tab will display the hard disk drive status. Refer to the Storage section
for details.
Figure 50 Event Status setup screen.
The Event Status screen displays the status of
the DVR’s systems and inputs. Events will be
highlighted, and related channels or events will
flicker for five seconds when detected.
Alarm-In, Motion and Video Loss will be
highlighted when each event is detected based
on the settings you made in the Alarm-In, Motion
Detection and Video Loss setup screen on the
Event menu.
To Next Page
Loading...
Need help?
General
