Adtech TV5600-B01 Series User Manual

User Manual of TV5600-B01 Series Dispensing Control System
72
Chapter 9
Monitoring Operation
We have already completed the reset setting, dispensing path editing, system setting, and file
parameter setting. The next is the monitoring operation, which is to observe the actual motion
effect.
1. -> Press [Monitor/Edit] button on the handheld box -> enter the monitoring interface
->
Parameter
Description
File number
0
Processing time
Display the time taken by the current program to complete processing
Error code
          

Batch production
number of products that have been
          
production
Total production
Display the current total processing
Total number of
lines
Display the current number of file instructions
Prompt message
The content includes the current working status and system error prompts.


F1 single step
processing
Select to enable single-step machining mode. In this mode, only one
programming point is run each time the start button is pressed
F2 simulation run
Do not open the glue after selecting
F3 cycle processing
Select to enable cycle processing mode; the number of cycles needs to

Adtech TV5600-B01 Series Specifications

General

Brand	Adtech
Model	TV5600-B01 Series
Category	Control Systems
Language	English