Micro-Ohmmeter Model 6250
11
2.5 Button Functions
In SET-UP mode, selects a function or increments a flashing parameter.
In SET-UP mode, selects a function or decrements a flashing parameter
In SET-UP mode, accesses the function to be modified.
In Wrap-Around mode, selects the parameter to be modified (from left to
right)
In SET-UP mode, shifts the decimal point and selects the unit.
Activates the secondary function of a button. The symbol appears on
the left side of the display.
PRINT
Immediate printing of the measurement to a serial printer. If the temperature
compensation function has been activated, the calculated result and the
temperatures involved are also printed.
PRINT
MEM
Retrieves stored data for printing (this function is independent of the setting
of the switch) except in the OFF and SET-UP positions.
Activates or deactivates the temperature compensation function to calcu-
late the resistance measured at a temperature other than ambient meas-
urement temperature.
ALARM
Activates or deactivates the alarms. High or low triggering values are
adjusted in SET-UP.
Selects the desired measurement mode prior to starting one of the follow-
ing measurements: Inductive mode (continuous test), non-inductive mode
(instantaneous test) or non-inductive mode with automatic triggering (mul-
tiple tests).
METAL
Selects the metal type for the temperature compensation calculation: Cu,
Al, or Other metal.
MEM
Stores the measurement at an address identified by an object number
(OBJ) and a test number (TEST).
Two presses on this button are required, one to select the location (use
the ▲ and ► buttons to change the location) and another to store the
measurement.
MR
Retrieves stored data (this function is independent of the selector setting
of the switch) except for the OFF and SET-UP positions. Data is viewed
using the ▲ and ► buttons. The
, and ALARM buttons can
be used.
Turns the display backlight ON or OFF.
Activates or deactivates the buzzer and adjusts the sound level.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
Need help?
General
