Micro-Ohmmeter Model 6250
57
CHAPTER 9
MAINTENANCE
Use only factory specied replacement parts. AEMC
®
will not be held
responsible for any accident, incident, or malfunction following a repair
done other than by its service center or by an approved repair center.
9.1 Warning
• To avoid electrical shock, do not attempt to perform any servicing
unless you are qualied to do so.
• Do not perform any service while the micro-ohmmeter is on any
circuit.
• To avoid electrical shock and/or damage to the instrument, do not
get water or other foreign agents into the electronic module.
• Make sure the internal battery is fully charged prior to testing. If
the instrument has been left unused for several months, recharge
the battery.
• We recommend recharging the micro-ohmmeter every month to
ensure a full battery charge when used.
• When replacing fuses, install only fuses which are direct replace-
ments.
9.2 Cleaning
WARNING: Disconnect the instrument from any source of electricity.
• If the case needs cleaning, do not use any alcohol or oil based
cleaners. Preferably use soapy water with a damp cloth or
sponge.
• Dry immediately after cleaning. Avoid water penetration into the
electronic module.
• Make sure the micro-ohmmeter and all leads are dry before fur-
ther use.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
