58
Micro-Ohmmeter Model 6250
9.3 Charging/Recharging the Battery
AC POWER SELECTION
The Model 6250 may be recharged from 90 to 264VAC (45 to 420Hz). The
instrument includes a 110V line cord, which provides the charging voltage
for the rechargeable battery.
CHARGING THE BATTERY
The Model 6250 should be charged to a full charge before using it for the
rst time. Charging to full capacity may take up to 6 hours for a completely
discharged battery
If the battery symbol is ashing, the battery needs to be recharged.
The battery will charge in both the ON and OFF mode.
• In the ON mode, the charging indicators will show on the display.
• In the OFF mode, no display will show during charging.
Connect the Model 6250 to 120VAC using the power cord provided (charg-
ing starts automatically).
NOTE: Testing can not be conducted while charging the batteries. Button
presses are ignored when charging is in process.
CHARGING INDICATORS
• bAt on the small display and CHrg on the main display, signies
fast charging in progress.
• bAt on the small display and CHrg ashing on the main display,
signies slow charging (starts o with fast charge, temperature
conditions permitting).
• bAt on the small display and FULL on the main display, signies
that charging is complete.
If the instrument is turned on and the battery voltage is >5V, then the
normal use of the device is permitted.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
