54
Micro-Ohmmeter Model 6250
CHAPTER 7
TROUBLESHOOTING
The Model 6250 incorporates internal diagnostics and will inform the oper-
ator of any condition needing attention through the use of error messages.
The available messages are described here.
7.1 Fault Indicators
Err 1 Low battery level
Err 2 Internal problem
Err 3 Unable to measure battery
Err 4 Unable to measure temperature
Err 5 Internal temperature too high - let the instrument cool down
Err 6 Unable to establish current measurement
Err 7 Measurement out of range
Err 8 Internal problem
Err 9 Measurement cycle stopped
Err 10 Temperature sensor incorrectly connected or missing
Err 11 Current leads incorrectly connected
Err 12 Voltage leads incorrectly connected or measured resistance
too high
Err 13 Residual voltage too high
Err 21 Adjustment out of range
Err 22 Measured value out of range
Err 23 Entry out of range
Err 24 Unable to write to memory
Err 25 Unable to read memory
Err 26 Memory full
Err 27 Memory empty; no data available
Err 28 Memory check problem
Err 29 Object or test number incorrect
WARNING: If error message 2, 3, 4, or 8 appears, the instrument must be
sent to a qualified organization for repair. See the Repair and Calibration
section for return instructions.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
