AEQ Audio Over IP
Routing System
44
- To display devices with either setting, select the 'Enabled' and 'Disabled'
checkboxes.
- To display devices that do not support Sync to External, select the
'Unsupported' checkbox.
• Latency Filter:
Use the Latency filter to display devices with a specific latency setting:
- To display only devices with a particular latency, select the appropriate
checkbox.
- To display only devices with one of a selection of latencies, click the
appropriate checkboxes.
• Subscriptions Filter:
Use the Subscriptions filter to display devices with a specific subscription state:
- To display only devices with one or more successful subscriptions, click the
'Success' checkbox.
- To display only devices with one or more failed subscriptions, click the 'Failure'
checkbox.
NOTE: ‘Success’ will not only display devices with only successful subscriptions – it will
also display devices with a mix of successful and failed subscriptions. Similarly, ‘Failure’
will also display devices with a mix of failed and successful subscriptions.
• Tx Multicast Flows Filter:
Use the Tx Multicast Flows filter to display only devices with Tx Multicast Flows
configured:
- To display only devices with one or more Tx Multicast Flows configured, select
the 'Active' checkbox.
• AES67 Filter:
Use the AES67 filter to display devices with a specific AES67 setting:
- To display devices with AES67 enabled, select the 'Enabled' checkbox.
- To display devices with AES67 disabled, select the 'Disabled' checkbox.
- To display devices with either setting, select the 'Enabled' and 'Disabled'
checkboxes.
- To display devices that do not support AES67, select the 'Unsupported'
checkbox.
• Sample Rate Pull-up Filter (this filter is not suitable for AEQ equipment):
Use the Sample Rate filter to display devices with a specific sample rate pull-up setting:
- To display only devices with a particular pull-up, select the appropriate
checkbox.
- To display only devices with one of a selection of pull-ups, click the appropriate
checkboxes.
To Next Page
Loading...
Need help?
General
