To Next Page

To Previous Page

AEQ XPEAK

IP Intercom System

• Xpeak mode: Up to 28-terminals matrix-less, Xplorer-compatible system, local and global

Plug & Play. 7 kHz HD audio. Native mode including all the features.

• Conexia mode: Xpeak beltpacks turn into 4-key user panels compatible with Conexia

intercom Matrix. Audio quality is 7 kHz HD.

• CrossNET mode: Xpeak beltpacks turn into 4-key user panels compatible with CrossNET

intercom Matrix. Audio quality is Kroma G711.

• EasyNET mode: Xpeak beltpacks integrate into the EasyNET 4-channel Party-Line system,

compatible with earlier panels and Xplorer. Audio quality is Kroma G711.

• EasyNET G722 mode: Xpeak beltpacks integrate into a 4-channel Party-Line system,

compatible with Xplorer wireless system. Audio quality is 7 kHz HD.

3.2.3. "Connection" menu.

By pressing the "PAGE (MUTE)" key when the

"Connection" option is visible on the screen, you

enter this menu which presents the following

options:

• IP: Allows us to modify the IP address of the beltpack.

When accessing this option, the first digit of the current IP address is

selected. By pressing the "PAGE (MUTE)" key, the cursor will be

highlighted in red. By turning the right encoder, the number can be

substituted by another. Numbers from 0 to 9 can be chosen (the figure

that can be configured in each octet is limited between 0 and 255).

By pressing the "PAGE (MUTE)" key again, the cursor is highlighted back in white so by

turning the right encoder we can move to another number of the IP address. By pressing

that key again, the cursor is highlighted in red and the number can be modified. The new IP

address must be confirmed by pressing the key 4, labeled with the "Save" legend (the

changes can be discarded by means of the "Cancel" option, associated to key 3).

If the IP address you are trying to configure is not correct, the octet number is automatically

corrected to a valid value (between 0 and 255).

• DHCP: Enables or disables automatic IP address configuration. When

this menu entry is highlighted, pressing the "PAGE (MUTE)" key

checks or disables this option.

• Mask: Configures the mask of the subnet the beltpack is connected to.

Its max. length is 32 bits (up to 255.255.255.255).

If you are not used to this format, remember that:

24 bits is equivalent to mask 255.255.255.0

16 bits is equivalent to mask 255.255.0.0

8 bits is equivalent to mask 255.0.0.0

The procedure to change the mask and confirm the changes is the same as the one defined

for the IP address.

AEQ XPEAK User Manual

Questions and Answers: