AEQ XPEAK
IP Intercom System
42
When the "SETTINGS" option is highlighted in green, by pressing the "SELECT" key this fourth
menu is accessed.
Any of the two encoders can be used to navigate through the 2 options of the menu and the
"SELECT" key allows to enter the selected one. The available options are:
• Screen: Allows to configure the following display parameters:
o Brightness: When this option is selected, an auxiliary screen appears where the
screen brightness can be modified using any of the two encoders within a range
from 1 (low) to 7 (high), in order to suit the operating environment ambient light.
Press the "OK" key when the adjusted brightness level is adequate.
To Next Page
Loading...
Need help?
General