EasyManuals Logo

AERMEC Turbocor User Manual

AERMEC Turbocor
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
A
2
B
1
12
Main monitor - ELECTRONIC VALVE page (not available for TW110)
ACTIONS
AVAILABLE:
A
Return to main monitor
B
Open the Alarms page (if an alarm is currently
present on the system, the icon will ash)
Index Meaning
1
They indicate the current values of the following parameters:
Mode = indicates the current status of the electronic valve, this status can be:
O: valve o;
On: valve operating;
Start: valve in start-up mode;
Alarm: valve in alarm;
Forced: valve in forced operation (compressor start-up);
Forced manual: valve in forced manual operation (support);
Forced at zero: valve in forced operation at zero (leak detection alarm);
Liquid level = level of liquid inside the attached heat exchanger;
Current setpoint = Indicates the percentage value of the liquid level to be reached for ooded
exchangers;
EEV A current position = opening percentage of valve A;
EEV A current steps = opening of valve A expressed in steps;
Digital input 1 = status of digital input ID1 on the electronic driver of the valve;
Digital input 2 = status of digital input ID2 on the electronic driver of the valve;
Relay = relay status on the electronic driver of the valve (green = On; grey = O);
2
They indicate, only visible on units with at least 3 compressors, the current values of the following
parameters:
EEV B current position = opening percentage of valve B;
EEV B current steps = opening of valve A expressed in steps;

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AERMEC Turbocor and is the answer not in the manual?

AERMEC Turbocor Specifications

General IconGeneral
BrandAERMEC
ModelTurbocor
CategoryChiller
LanguageEnglish

Related product manuals