To Next Page

To Previous Page

Main monitor - EVAPORATOR page

ACTIONS

AVAILABLE:

Return to main monitor

Open the Alarms page (if an alarm is currently

present on the system, the icon will ash)

Index Meaning

They indicate the current values of the following parameters:

Evap.water inlet = indicates the temperature of the evaporator water inlet;

Evap.water outlet = indicates the temperature of the evaporator water outlet;

Mode = indicates the current status of the evaporator and any preventions of the machine, this

status can be:

• O: heat exchanger not active;

• On: heat exchanger active;

• High pressure prevention: heat exchanger in prevention mode for high condensation

pressure;

• Low pressure prevention: heat exchanger in prevention mode for low evaporation pressure;

• Low temperature prevention: heat exchanger in prevention mode for low evaporator

temperature;

Pul. pump 1 / Pul. pump 2 = indicates the current status of the pumps to the evaporator (based on

the unit they can be one or two), this status can be:

• O: pump not active;

• On: pump active;

• Switch-o: pump in switch-o stage;

• Flow switch: ow switch alarm;

• Pump inversion: change between pump 1 and pump 2 in progress;

• Alarm: pump in alarm;

• Force On: pump forced in on mode;

• Not present: pump not present;

They indicate the current values of the following parameters:

Current setpoint = It indicates the value of the setpoint currently set

Current dierential = It indicates the value of the dierential applied to the setpoint;

Proportional error =

It indicates the percentage value relative to the proportional error of the PID

logic;

Integral error = It indicates the percentage value relative to the integral error of the PID logic;

Total request = It indicates the percentage value of the thermostat request;

Maximum request limit = level of potential power limitation of the thermostat;

AERMEC Turbocor User Manual

Questions and Answers: