AERMEC Turbocor User Manual

A
E
B
C
2
D
F
G
I
L
H
3
1
15
ON/OFF MENU
This page enables to manage the crucial commands of the uni. Through
this window the user can turn the machine on or o, set the values
relave to the setpoints and, for the units that require it, set the seasonal
operang mode
On/O menu - Main page
Index Meaning
1 Indicates the setpoint value currently set
2
Indicates the current status of the unit. This status can be:
WAIT = Unit waiting for control board start (5 seconds);
ON = Unit active;
OFF from alarm = Unit stopped due to alarm;
Board restart = Unit waiting for start procedure (20 seconds);
OFF from BMS = Unit turned o via command incoming from BMS;
OFF from time = Unit turned o from time setting;
OFF from ID = Unit turned o via digital input (ID1);
OFF from Dispaly = Unit turned o from pressing the key on the touch display (
C
);
3 Indicates the operating mode currently set for the unit;
ATTENTION: some pages (or items within the same pages) of
this menu may not be visible as they are specic for certain
models or types of unit (depending on the conguraon,
some components may not be available), however, this
manual will list all possible pages. For further informaon
on the components present in the unit, refer to the technical
manual.
ACTIONS
AVAILABLE:
A
Open the menu selecting page
B
Open the Alarms page (if an alarm is currently
present on the system, the icon will ash)
C
Enables to turn the unit on or o (it turns on if the
background is green, o if it is white)
D
If the unit is a heat pump, it enables to select the
operating mode. Each press will change the status
(blue = cooling, orange = heating). Moreover the
active mode will be indicated in full next to the key
E
It enables to select which setpoint to use on the unit,
by selecting it from a drop-down menu that will
contain:
SET1 = enables setpoint 1;
SET2 = enables setpoint 2;
PERIODS = enables operation through the time
program (in this case, the button (
H
) to access the
TIME PERIODS page for the relative settings will
appear
F
It enables to set the value related to SETPOINT1 to be
used in cooling mode
G
It enables to set the value related to SETPOINT2 to be
used in cooling mode
H
Enables to access the TIME PERIODS page. This key
only appears if the "periods" option is selected in the
eld (
E
)
I
If the unit is a heat pump, the SETPOINT1, to be used
for heating, will be displayed (and can be set)
L
If the unit is a heat pump, the SETPOINT2, to be used
for heating, will be displayed (and can be set)

AERMEC Turbocor Specifications

General

Brand	AERMEC
Model	Turbocor
Category	Chiller
Language	English