AERMEC Turbocor - INSTALLER menu - Setting the climatic curve; INSTALLER menu - Limit power request setting

A
A
B
B
C
D
E
F
G
D
C
1
29
INSTALLER menu - CHILLER submenu - Seng the climac curve to be used in cooling (only air/water unit)
INSTALLER menu - CHILLER submenu - limit power request seng of the thermostat
ACTIONS
AVAILABLE:
ACTIONS
AVAILABLE:
A
Return to the submenu selection page for the
INSTALLER menu
B
Go to alarm menu
C
Go to next page
D
Go back to previous page
E
Sets the external air temperature below which the cold
setpoint is not compensated
F
Sets the external air temperature above which the cold
setpoint is compensated with the value indicated in
the parameter (
G
)
G
Sets the maximum oset to be applied to the cold
setpoint at the maximum external air temperature
value (
F
). Naturally, for external air temperature
values between (
E
) and (
F
), the oset to be applied
to the setpoint will be between 0 and (
G
), calculated
directly proporonally to the increase in the external
air temperature (as shown in the graph)
A
Return to the submenu selection page for the
INSTALLER menu
B
Go to alarm menu
C
Go back to previous page
D
Set a potenal power request limit of the thermostat
to prevent alarm condions or set a maximum ceiling
on unit consumpons
Index Meaning
1
Indicates the current value of the following parameters:
Ext.temp. = value of the external air temperature;
Current set. = current value calculated for the cold setpoint based on the external temperature;