AGFA Drystar 5301 - Available Software Versions

Available Software versions
The table below lists the available software versions and the type of printer
they require:
Software
version
(SW)
Printer
1.8.x supports Drystar 5302
1.9.x supports Drystar 5302 (RoHS compliant)
2.0 supports both Drystar 5302 & Drystar AXYS
2.1 and 2.2 support new PCBs on Drystar 5302 & Drystar Axys
2.3 maintenance software version
3.x supporting first Private label printer
4.0 support of additional printer models
5.0
• support for single tray models
• Supports Sata Dom
• Supports Spare-Parts without E-lables
5.1 support of additional printer models
6.0 required for devices with serial number higher than 100000
6.1 is a maintenance software + supports DRY IMAGER
6.1.x maintenance software
6.2 is needed for new Devnix PCB index 16 and higher
6.2.1 maintenance software
6.2.2 required for for devices with serial numbers higher than
751001 and for devices with serial numbers higher than
151001 and lower than 700000
10 | Drystar 5301, Drystar 5302 | Drystar 5301, Drystar 5302
2831F EN 20210601 1655