Loading films
This section describes how to load the printer with appropriate films.
The printer can be loaded with 8x10”, 10x12”, 11x14”, 14x14” and 14x17”
films.
Note: If you want to change the film format, the tray
configuration must be modified.
The printer will inform you in several ways when a film tray is empty:
• an audible signal,
• the status indicator LED is blinking (red color),
• the display screen shows a message informing you that the input tray is
empty.
The film loading procedure is identical for both input trays. In the examples
below, we will assume that the lower input tray is to be loaded.
Note: The procedure is slightly different, depending on the fact
wether the printer is printing/calculating or in the ready state.
WARNING:
Never load an additional film sheet or film sheets to a film pack
in use. Only load a new film pack when the current input tray is
empty.
Related Links
Changing the film format of the trays on page 80
Topics:
• When the printer is printing or calculating and an input tray is empty
• When the printer is in the ready state and an input tray is empty
• Film loading procedure
• Checking the correct position of a film in the input tray
Drystar 5301, Drystar 5302 | Basic Operation (operator mode) | 83
2831F EN 20210601 1655
To Next Page
Loading...
