Transport after installation
WARNING:
Before moving the printer, always switch off the machine.
WARNING:
The printer must only be transported with all covers closed.
WARNING:
Do not lift the printer by the output tray.
WARNING:
When transporting the printer, the stability and the structure of
the tabletop have to be taken into account. The printer should
not be placed on a soft surface, since this might prevent
appropriate ventilation and cause overheating. Make sure the
printer is placed on a stable, hard surface table.
WARNING:
The appliance may not be transported continuously from one
location to the other.
WARNING:
The printer should be transported by 3 persons or if not possible
with 2. Refer to the Installation manual for more information.
30 | Drystar 5301, Drystar 5302 | Introduction
2831F EN 20210601 1655
To Next Page
Loading...
