38 1260 Infinity II Analytical-Scale & Bio-inert Fraction Collector User Manual
3
Using the Module
Configuration and Operation of the Fraction Collector
Finalize Calibration
The Finalize Calibration page of the Delay Calibration Wizard leads you through the
clean-up of the instrument back to its pre-calibration state.
The required clean-up steps are listed in a three-column table:
Delay Calibration - Close
This dialog box is displayed when you click Cancel after the delay calibration
preparation procedure has been started. It allows you to select the action to
take when the calibration procedure is canceled:
Activity A short description of the preparation activity.
Status The current status of the preparation activity. When the activity
is complete, the status is Done.
Info Any additional information about the activity, for example, user
interaction.
Start Clean-Up Procedure Click to start the clean-up of the instrument; follow any
on-screen instructions that appear during the process.
Back Displays the Perform Calibration Run page of the Delay
Calibration Wizard (“Perform Calibration Run” on page 37).
Cancel Displays the “Delay Calibration - Close” on page 38 dialog box.
Finish Closes the Delay Calibration Wizard.
This button is not displayed until the clean-up is complete.
Perform Finalize Calibration Carries out the clean-up steps required to bring the instrument
back to its original state.
This is the recommended action.
Cancel Calibration Aborts the calibration immediately.
If you select this option, the instrument may not be in a
usable state.
Continue Calibration Continues with the delay calibration procedure.
To Next Page
Loading...
Need help?
General
