Agilent Technologies 4349B - Instrument Error Codes

4349B
Instrument Errors
11
ADC
F
AILURE
The
A/D
conversion
failed.
The
4349B
stops
operation
and
asserts
the
/ALARM signal
on the
handler
interface
.
Contact
your
nearest
Agilent
T
echnologies
oce
.
12
ROM
TEST
F
AILED
The
ROM
failed.
When
this
error
occurs
during
power-on
test,
the
4349B
stops
operation
and
asserts
the
/ALARM
signal
on
the
handler
interface
.
When
this
error
occurs
during
self-test,
the
4349B
continues
operation
and
asserts
the
/ALARM
signal.
Contact
your
nearest
Agilent
T
echnologies
oce
.
13
RAM
TEST
F
AILED
The
RAM
failed. The
4349B stops
operation and
asserts
the
/ALARM
signal
on
the
handler
interface.
Contact your
nearest
Agilent
T
echnologies
oce
.
14
EEPROM
R/W
F
AILED
The
EEPROM
read/write
test failed.
The 4349B
stops operation
and asserts
the
/ALARM
signal
on
the
handler
interface.
Contact your
nearest Agilent
Technologies
oce
.
15
USER
D
A
T
ALOST
Correction
data
and
instrument
settings
saved
in
EEPROM
have
been
lost.
When
this
error
occurs
during
power-on
test,
the
4349B
sets
the
data
in
the
EEPROM
to
the factory
default
settings
,
continues
operation,
and
does
not
assert
the
/ALARM
signal
on
the
handler
interface.
When
this
error
occurs
during
self-test,
the
4349B
continues
the
operation
and
asserts
the
/ALARM
signal.
Contact
your
nearest
Agilent
T
echnologies
oce
.
16
PREV
.
SETTING
LOST
Instrument
settings
in the
backup memory
have been
lost. The
instrument
keeps
instrument
settings in
backup
memory
for
72
hours
after
being
turned
OFF
.
When
this
error
occurs
during
power-on test,
the
4349B
continues
operation
and
does
not
assert
the
/ALARM
signal
on
the
handler interface
.
When
this
error
occurs
during
self-test,
the
4349B
stops
operation
and
asserts the
/ALARM signal.
17
S
A
VE
F
AILED
The instrument setting cannot be saved for some reason. (If the error is detected in the
EEPROM, error 14 is displayed.) The 4349B continues operation and does not assert the
/ALARM signal on the handler interface
.
18 RECALL
FAILED
No instrument setting saved in the
EEPROM. (If the error is detected in the EEPROM, error 14
is displayed.) The 4349B continues operation and
does not assert the /ALARM signal on the
handler interface.
19 PRINTER NO RESPONSE
Check the following items:
Check that the printer is turned on.
Check that the GPIB cable is connected between the printer and the instrument.
Messages-2