112 708-DS / 709-DS Operator’s Manual
4 Operating the 708-DS / 709-DS
Spindle Speed Error
This Spindle Error screen displays when the spindle speed has exceeded
the allowable tolerance range (“Menu Screen - Instrument Settings
Screen 2” on page 84). Press Ok to resume the test and send a message
to the printer, if installed.
Fatal Spindle Error
• This Spindle Error screen displays when a serious error has
been detected with the spindle motor. For the safety of the
equipment and the operator, remove power before
correcting the problem. Errors may include jammed
paddles, obstructions in the path of the drive belt, and
severe deterioration of the spindle motor.
• Contact Agilent Customer Care (“Obtaining Warranty and
Other Services” on page 134).
Autosampling Manifold Errors
The Stepper Motor Errors screen shows all of the possible errors
associated with the manifold stepper motor. A red X displays before the
current error condition. If a stepper motor error is encountered, the
current run is stopped. You can press Ignore to disregard the error, but it
must be corrected before a run may be restarted. Press Retry to re-test
the stepper motor for errors.
Autosampling Manifold Error Action
Over Current
• Contact Agilent Customer Care (“Obtaining Warranty and
Other Services” on page 134).
Over Temperature
Under Voltage
Controller Command Retry Error
Open Load
Timeout
Table 1 7 Error Screens (Red)
To Next Page
Loading...
