708-DS / 709-DS Operator’s Manual 7
Figures
Figure 1. Unpacking 20
Figure 2. Removing the Apparatus 21
Figure 3. BATH HEATER Connector 24
Figure 4. Levelers and Stability Feet 25
Figure 5. Level-Adjustment Screw Caps 26
Figure 6. Raising the Stability Feet 27
Figure 7. DVH Power Controller 28
Figure 8. BATH TEMP Connector 29
Figure 9. Positioning the Temperature Probe 29
Figure 10. Filling the Water Bath 31
Figure 11. Vessel Bubble 34
Figure 12. Positioning the Manifold for Installation 35
Figure 13. Connecting AutoTemp 36
Figure 14. Affixing the Fasteners 37
Figure 15. Proper Sample Tubing Position 38
Figure 16. Installing Evaporation Covers on Shafts 39
Figure 17. Shaft Locking Collars 39
Figure 18. Dosage Delivery Module and Alignment Post 40
Figure 19. Inserting DDM into DDM Alignment Shaft 41
Figure 20. Attaching DDM to Alignment Post 42
Figure 21. Accessory Installation 43
Figure 22. Tightening the Shaft Locking Collar 44
Figure 23. Inserting Height Spheres 45
Figure 24. Main Screen - Display Parameters 48
Figure 25. Manual Lift Knob 60
Figure 26. Taking a Manual Sample 61
Figure 27. Agilent 708-DS / 709-DS Standard Evaporation
Cover 62
Figure 28. Rinse Cup 120
To Next Page
Loading...
Need help?
General
