Error Messages SYST:ERR?
380 Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Sixth Edition
SYST:ERR?
The syst:err? command returns the next error from the error queue (refer to the
Programming Guide for details).
Each error has an error code and a short description of the error, separated by
comma. Please note that the error codes are returned as signed integer numbers
in a range from -32768 to +32767 (INT16). Negative error numbers are defined by
the SCPI standard, positive error numbers are device dependent.
Please find below a complete list of all implemented error codes:
-185, "Subop out of range"
-200, "Execution error (StatExecError)"
+200, "Please be patient - GPIB currently locked out"
-205, "Powermeter not running (StatMeterNotRunning)"
-211, "Trigger ignored"
-212, "Arm ignored"
-213, "Init ignored"
-220, "Parameter error (StatParmError)"
-220, "Parameter error (StatParmOutOfRange)"
-220, "Parameter error (StatParmIllegalVal)"
-221, "Settings conflict (StatParmInconsistent)"
-222, "Data out of range (StatParmTooLarge)"
-222, "Data out of range (StatParmTooSmall)"
-231, "Data questionable (StatValNYetAcc)"
-231, "Data questionable (StatRangeTooLow)"
-261, "Math error in expression (StatUnitCalculationError)"
-284, "Function currently running (StatModuleBusy)"
-286, "No function currently running"
-290, "Application currently running - no GPIB support"
-300, "Internal error"
-300, "Internal error (StatValsLost)"
-300, "Internal error (StatInternalError)"
-301, "Module doesn't support this command (StatCmdUnknown)"
-302, "Internal timeout error (StatTimedOut)"
-303, "Module slot empty or slot / channel invalid"
-304, "Command was aborted (StatAborted)"
-305, "Internal messaging error (StatCmdError)"
-305, "Internal messaging error (StatCmdNotAllowed)"
To Next Page
Loading...
Need help?
General
