Agilent Technologies 8360 B Series User Manual

320 to 330: Connect the source output signal to the output
terminals.
340 to 380: Print results table header.
390 to 460: This is the main measurement lo op. Line 400 contains
two commands. :SOURce:VOLT sets the output level of the source.
*OPC? is used to signal that the preceding command has nished
executing. To make an accurate measurement, the source output
must be allowed to settle. When the output has settled, *OPC? places
a 1 in the source Output Queue. The program waits at line 410 until
the 1 returned by *OPC? is entered.
Note that following each OUTPUT containing a query is an ENTER to
retrieve the queried value. If you do not use paired OUTPUT s and
ENTER s, you can overwrite data in the instrument Output Queue and
generate instrument errors.
470 to 480: Disconnect output terminals of the instruments from the
unit under test, and end the program. All HP BASIC programs must
have END as the last statement of the main program.
Getting Started Programming 1-79

Agilent Technologies 8360 B Series Specifications

General

Brand	Agilent Technologies
Model	8360 B Series
Category	Portable Generator
Language	English