NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Auto Fill #Pts
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Auto Fill #Pts
Function Group
FREQUENCY, POWER
Menu Map
2, 5
Description
This softkey is used in two lo cations:
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Fltness Menu
and
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
List Menu
.
Flatness Menu - When selected, the swept signal generator waits for
anumeric value representing the number of correction points to be
entered.
--> Number of Correction Points:
is displayed in the
active entry area. A list of frequencies containing the number of
specied points is created automatically. The list begins at the auto
ll start frequency and ends at the auto ll stop frequency. The rest
of the points are equally spaced b etween them. A minimum of two
points must be entered.
If the number of p oints requested creates a list that exceeds the
number of elements available (801), the following message appears:
TOO MANY CORRECTION PTS REQUESTED
List Menu - When selected, the swept signal generator waits for a
numeric value representing the number of list points to b e entered.
--> Number of List Frequencies:
is displayed in the active
entry area. A list of frequencies containing the number of sp ecied
points is created automatically. The list b egins at the auto ll start
frequency and ends at the auto ll stop frequency
. The rest of the
points are equally spaced b etween them. A minimum of two p oints
must be entered.
If the number of p oints requested creates a list that exceeds the
number of points available (801), the following message appears:
Error...too many list points requested.
Points used: 0
Points available: 801
Programming Codes
SCPI:
NONE, see
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Fltness Menu
or
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
List Menu
Analyzer:
NONE
See Also
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Fltness Menu
,
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
List Menu
\Optimizing Swept Signal Generator Performance" in Chapter 1
Operating and Programming Reference A-25
To Next Page
Loading...
Need help?
General
