Agilent Technologies 8360 B Series User Manual

R
4
RECALL
5
Function Group
SYSTEM
Menu Map
8
Description
This hardkey retrieves a front panel setting that was previously
stored in a SAVE register (1 through 8).
Programming Codes
SCPI: *RCL < num >
The above is an IEEE 488.2 common command.
Analyzer: RCn, where n= a numeric value from 0 to 9.
See Also
4
SAVE
5 , SCPI COMMAND SUMMARY
\Saving and Recalling an Instrument State" in Chapter 1
\Programming Typical Measurements" in Chapter 1
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Ref Osc Menu
Function Group
SYSTEM
Menu Map
8
Description
This softkey reveals the softkeys in the frequency standard men
u.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
10 MHz Freq Standard Auto
Automatically selects the frequency
standard to be used by the swept
signal generator.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
10 MHz Freq Standard Extrnl
Sets the swept signal generator
to accept an external frequency
standard as its reference.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
10 MHz Freq Standard Intrnl Sets the swept signal generator to
use its internal frequency standard
as its reference.
Operating and Programming Reference R-1

Agilent Technologies 8360 B Series Specifications

General

Brand	Agilent Technologies
Model	8360 B Series
Category	Portable Generator
Language	English