Agilent Technologies 8360 B Series User Manual

C
4
CENTER
5
Function Group
FREQUENCY
Menu Map
NONE
Description
This hardkey lets you select the center frequency for center
frequency/frequency span swept op eration. When you press 4
CENTER
5 ,
the swept signal generator displays: --> CENTER: XXXXX MHz , where
XXXXX represents a frequency value. Use the entry area to set the
desired value.
Certain center frequency and frequency span combinations cause the
swept signal generator to limit the value entered. In general, any
combination that would cause the swept signal generator to exceed
its minimum or maximum specied frequency will b e limited.
Programming Codes
SCPI:
FREQuency:CENTer < num > [freq sux] or
MAXimum j MINimum j UP j DOWN
FREQuency:MODE SWEep
Analyzer: CF
See Also
4
SPAN
5 , 4
START
5 , 4
STOP
5
\Center Frequency/Span Operation" in Chapter 1
Operating and Programming Reference C-1

Agilent Technologies 8360 B Series Specifications

General

Brand	Agilent Technologies
Model	8360 B Series
Category	Portable Generator
Language	English