Agilent Technologies 8360 B Series User Manual

SCPI COMMAND SUMMARY
 *WAI
This causes the swept signal generator to wait for the p ending
commands to b e completed b efore executing any other commands.
For example, sending the command: TSW;*WAI
allows for synchronous sweep op eration. It causes the swept signal
generator to start a sweep and wait until the sweep is completed
before executing the next command.
Table S-1. 8360 SCPI COMMAND SUMMARY
Command Parameters Parameter Type
1
Allowed Values
:ABORt
:AM
[:DEPth] AM depth % numeric 0to40dB
INTernal
:FREQuency AM frequency extended numeric < num > [freq sux]
or MAXimum j Minimum
:FUNCtion waveform discrete SINusoid j SQUare
TRIangle j RAMP j NOISe
:MODE AM depth discrete DEEP j NORMal
:SOURce AM source discrete INTernal j EXTernal
:STATe state Bo olean ON j OFF j 1 j 0
:TYPE AM typ e discrete LINear j EXPonential
:CALibration
:AM
:AUTO auto calibrate Bo olean ON j OFF j 1 j 0
[:EXECute]
:PEAKing
:AUTO auto RF p eak Bo olean ON j OFF j 1 j 0
[:EXECute]
:PMETer
:DETector
:INITiate? typ e of det cal discrete IDETector j DIODe
:NEXT? power correction
value
extended numeric < num > [lvl sux]
1 Parameter typ es are explained in the \Getting Started Programming" chapter.
S-18 Operating and Programming Reference

Agilent Technologies 8360 B Series Specifications

General

Brand	Agilent Technologies
Model	8360 B Series
Category	Portable Generator
Language	English