Agilent Technologies 8360 B Series - Page 331

SCPI COMMAND SUMMARY
Table S-1. 8360 SCPI COMMAND SUMMARY (continued)
Command Parameters Parameter Type
1
Allowed Values
:PULM
:EXTernal
:POLarity extnl pulse p olarity discrete NORMal j INVerted
:DELay extnl pulse delay extended numeric < num > [time sux]
or MAXimum j MINimum
:INTernal
:FREQuency intnl pulse frequency extended numeric < num > [freq sux]
or MAXimum j MINimum
:GATE intnl pulse gating Boolean ON j OFF j 1 j 0
:PERio d intnl pulse p erio d extended numeric < num > [time sux]
or MAXimum j MINimum
:TRIGger
:SOURce pulse trigger source discrete INTernal j EXTernal
:WIDTh intnl pulse width extended numeric < num > [time sux]
or MAXimum j MINimum
:SLEW pulse mo dulation extended numeric < num > [time sux]
or MAXimum j MINimum
:AUTO pulse mo d rise time Bo olean ON j OFF j 1 j 0
:SOURce pulse mo d source discrete INTernal j EXTernal j SCALar
:STATe state Bo olean ON j OFF j 1 j 0
:ROSCillator
:SOURce ref osc source discrete INTernal j EXTernal j NONE
:AUTO state Bo olean ON j OFF j 1 j 0
:STATus
:OPERation
:CONDition?
:ENABle numeric 0 to 2047
[:EVENt]?
:NTRansition neg transition lter numeric 0 to 2047
:PTRansition pos transition lter numeric 0 to 2047
:PRESet
S-24 Operating and Programming Reference