SCPI COMMAND SUMMARY
STATUS:PRESet
This command presets the following enable and transition registers:
MSIB, OPERation, QUEStionable, and SRECeiver.
ENABle Is set to all 0s.
NTRansition Is set to all 0s.
PTRansition All bits used are set to 1s. Unused bits remain 0s.
STATus:QUEStionable:CONDition?
Queries the Data Questionable Condition Register.
STATus:QUEStionable:ENABle <num>
STATus:QUEStionable:ENABle?
Sets and queries the Data Questionable SRQ Enable register.
The
STATus:PRESet
value is 0.
STATus:QUEStionable[:EVENt]?
Queries the Data Questionable Event Register. This is a destructive
read.
STATus:QUEStionable:NTRansition <num>
STATus:QUEStionable:NTRansition?
Sets and queries the Negative TRansition Filter for the Data
Questionable Status Register. The
STATus:PRESet
value is 0.
STATus:QUEStionable:PTRansition <num>
STATus:QUEStionable:PTRansition?
Sets and queries the Positive TRansition Filter for the Data
Questionable Status Register. After
STATus:PRESet
, all used bits are
set to 1s.
S-48 Operating and Programming Reference
To Next Page
Loading...
Need help?
General
