SCPI COMMAND SUMMARY
then governed by the equation DWELl = SWEEPTIME/POINTS.
Changing either sweep time or the number of points causes DWELl
to be recalculated but do es not cause an error. If you attempt to
change the dwell time then
:AUTO
is set to
OFF
.If
DWELl:AUTO
is
OFF
then sweep time is independent of the dwell time and the number of
points. *RST value is
MIN
.
SWEep:TIME:AUTO ON|OFF|1|0
SWEep:TIME:AUTO?
Sets and queries the automatic sweep time switch.
ON The value of the sweep time is automatically to
minimum.
OFF Attempting to set a sweep time faster than allowed
in the AUTO mo de causes this switchtochange to
AUTO ON
even if it was previously in the
AUTO OFF
mo de.
*RST state is
ON
.
SWEep:TIME:LLIMit <num>[time suffix]|MAXimum|MINimum
SWEep:TIME:LLIMit? [MAXimum|MINimum]
Sets and queries the lower sweep time limit. This value sp ecies the
fastest sweep time that you wants the swept signal generator to allow
either on input or when calculated internally when in
AUTO ON
mo de.
This value must b e greater than 10 ms. *RST v
alue is 10 ms.
SWEep:TRIGger:SOURce IMMediate|BUS|EXTernal
SWEep:TRIGger:SOURce?
Sets and queries the stepped sweep point-to-p oint trigger source.
This only applies when
SWEep:GEN
is set to
STEPped
.
SYSTem:ALTernate <num>|MAXimum|MINimum
SYSTem:ALTernate? [MAXimum|MINimum]
Sets and queries the save/recall register number to alternate the
foreground state of the instrument. The *RST value is 1.
SYSTem:ALTernate:STATe ON|OFF|1|0
SYSTem:ALTernate:STATe?
Sets and queries the state of the Alternate State function.
*RST setting is
OFF
.
SYSTem:COMMunicate:GPIB:ADDRess <n>
Changes the GPIB's (General Purp ose Interface Bus) address.
The *RST value is 19.
S-52 Operating and Programming Reference
To Next Page
Loading...
Need help?
General
