9-4 Programmer’s Guide
Introduction to SCPI
The Command Tree
The analyzer's major SCPI subsystems and their functions are described
below.
ABORt Aborts any sweep in progress.
CALCulate Configures post-measurement processing of the
measured data (such as marker and limit testing
functions).
CALibration Controls zeroing the broadband diode detectors.
CONFigure Configures the analyzer to measure a specific device
type, including amplifiers, mixers, filters, and cables.
CONTrol Configures the analyzer for use with a multiport test
set. Used with the 87075C multiport test set only.
DIAGnostic Performs a number of diagnostic and I/O functions.
Includes LAN diagnostics, port reads and writes,
correction constants utilities, and other miscellaneous
functions.
DISPlay Controls the display of measurement data, annotation
and user graphics.
FORMat Controls the format of data transfers over the GPIB.
For more information about GPIB data transfers, refer
to Chapter 4, “Data Types and Encoding.”
HCOPy Controls hardcopy (printer and plotter) output.
INITiate Controls the triggering of sweeps.
MMEMory Controls mass storage of instrument states and data
(disk and internal memory interface functions).
OUTPut Turns on/off the source output power (power to the
device under test).
POWer Specifies frequency sweeps or power sweeps.
PROGram Interfaces IBASIC programs and commands with an
external controller. For more information on IBASIC
programming, refer to HP Instrument BASIC User's
Handbook.
ROUTe Selects transmission and reflection ports.
Selects ports on multiport test sets (used with the
87075C multiport test set only).
To Next Page
Loading...
Need help?
General
