Programmer’s Guide 5-15
Using Status Registers
The Analyzer's Status Register Sets
Device Status Register Set
The Device Status register set monitors the state of device-specific
parameters.
Bits in the Device Status condition register are set to 1 under the
following conditions:
Key Pressed
(bit 0) is set to 1 when one of the analyzer's front panel keys
has been pressed.
Any Softkey Pressed
(bit 1) is set to 1 when one of the analyzer's softkeys has been
pressed.
Any External Keyboard Key Pressed
(bit 2) is set to 1 when a key has been pressed on an external
keyboard connected to the DIN KEYBOARD connector on the
rear panel of the analyzer.
Front Panel Knob Turned
(bit 3) is set to 1 when the analyzer's front panel knob is
turned.
To Next Page
Loading...
