SWEep Subsystem Introduction
Parameter Typical Return
Enable sweep:
SWE:STAT ON
[SOURce[1|2]:]SWEep:TIME {<seconds>|MINimum|MAXimum}
[SOURce[1|2]:]SWEep:TIME? [{MINimum|MAXimum}]
Sets time (seconds) to sweep from start frequency to stop frequency.
Parameter Typical Return
1 ms to 250,000 s for linear sweep, up to 500 s for logarithmic sweep;
default 1 s
+2.500000000000000E+01
Set sweep time to 25 s:
SWE:TIME 25
l The number of discrete frequency points in the sweep is calculated based on the sweep time.
298 Agilent 33500 Series Operating and Service Guide
To Next Page
Loading...
