16 Chapter2
Setting Up the EDGE (with GSM) Mode
Accessing the Mode
Accessing the Mode
At initial power up, the transmitter tester will come up in the Basic
mode, with the Spectrum (Frequency Domain) measurement selected
and the Measure menu displayed.
To access the EDGE (with GSM) measurement personality, press the
MODE key and select the EDGE w/GSM key.
If you want to set the mode to a known factory default state, press
Preset. This will preset the mode setup and all of the measurements to
the factory default parameters.
NOTE Note that pressing the Preset key does not switch instrument modes.
You may want to install a new personality, reinstall a personality that
you have previously uninstalled, or uninstall a personality option.
Instructions can be found in “Installing Optional Measurement
Personalities” later in this section.
To Next Page
Loading...
