Chapter 3 55
Making EDGE (with GSM) Measurements
Making the Transmit Power Measurement
Making the Measurement
NOTE The factory default settings provide a EDGE (with GSM) compliant
measurement. For special requirements, you may need to change some
of the settings. Press
Meas Setup, More (1 of 2), Restore Meas Defaults at
any time to return all parameters for the current measurement to their
default settings.
Select the desired ARFCN, center frequency, timeslot, burst type, and
TSC (Training Sequence Code) as described in the section titled
“Changing the Frequency Channel” on page 24.
Press
Measure, Transmit Pwr to immediately make Transmit Power the
active measurement.
To change any of the measurement parameters from the factory default
values, refer to the “Changing the Measurement Setup” section for this
measurement.
To Next Page
Loading...
Need help?
General
