4-24 Chapter4
Troubleshooting
Error Message Types
201 to 799:
Device-Specific
Errors
These errors indicate that a device operation did not properly complete,
possibly due to an abnormal hardware or firmware condition. These
codes are also used for self-test response errors. Errors in this class set
the device-specific error bit (bit 3) in the event status register (IEEE
488.2, section 11.5.1).
The <error_message> string for a positive error is not part of the SCPI
standard. A positive error indicates that the instrument detected an
error within the GPIB system, within the instrument firmware or
hardware, during the transfer of block data, or during calibration.
Greater than
1000:
Personality
Specific Error
Messages
These errors indicate that an error has been detected while executing
measurements requiring Option BAH.
To Next Page
Loading...
Need help?
General
