4-44 Chapter4
Troubleshooting
201 to 799: Device-Specific Errors
207 Unable to store flatness data
A failure occurred in setting the flatness data in the
internal EEROM. Contact your local Agilent
Technologies sales and service office.
703 Unknown printer
In attempting to identify the printer, a valid response
was received but the printer is not known to the
analyzer. Use the Custom printer menu under Print
Setup to configure the printer.
702 Unsupported printer
A printer which is recognized, but known to be
unsupported was identified. This printer cannot be
used with the analyzer. For example, a printer only
supported by Microsoft Windows will generate this
error.
617 Wrong density floppy inserted
The floppy disk has the wrong density. It should be
1.44 MB.
To Next Page
Loading...
Need help?
General
