3 Adjustments
60 E4416A/E4417A Power Meters Service Guide
Introduction
This chapter describes adjustments and checks which ensure proper
performance of the power meter.
Adjustments are not usually required on any regular basis. They are normally
performed only after a performance test has indicated that some parameters
are out of specification. Performance tests must be completed after any
repairs that may have altered the characteristics of the power meter.
Performance tests are detailed in Chapter 2. To determine which performance
tests and adjustments to perform after a repair, see “Post- Repair
Adjustments” on page 61.
Safety Considerations
This warning must be followed for your protection and to avoid damage to the
equipment being used.
Equipment Required
The adjustment procedures include a list of recommended test equipment. The
test equipment is also identified on the test setup diagrams.
Adjustments described in this chapter are performed with power applied to the
instrument and with protective covers removed. Maintenance should be
performed only by trained personnel who are aware of the hazards involved.
When the maintenance procedure can be performed without power, the power
should be removed.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
