Agilent Technologies U1253B

90 U1253B User’s and Service Guide
4 Changing the Default Settings
Setting data logging mode
1 Set to “HAND” to enable manual (hand) data logging, or
set to “TIME” to enable interval (time) data logging. Refer
to Figure 4- 3 below.
Figure 4-3 Data logging setup
2 For interval (time) data logging, set the LOG TIME within
the range of 0001 second to 9999 seconds to specify the
data logging interval.
Press Hz
to edit
to switch between
HAND (data logging) and
TIME (interval logging)
Press or
Press Hz to save
and exit
or press Esc
to exit without saving