108 U1253B User’s and Service Guide
4 Changing the Default Settings
Setting print mode
Turning print mode “ON” enables the printing of measured
data to a PC that is connected to the multimeter via the
remote interface when a measurement cycle is completed.
In this mode, the multimeter continuously sends the latest
data to the host, but does not accept any commands from
the host.
The indicator flashes during print operation.
Figure 4-21 Print mode setup for remote control
to switch between
OFF and ON
Press or
Press Hz
to edit
Press Hz to save
and exit
or press Esc
to exit without saving
To Next Page
Loading...
