118 U1253B User’s and Service Guide
4 Changing the Default Settings
Setting the DC filter
This setting is used to filter AC signal in DC measuring
path. The DC filter is set to “OFF” by default. To enable this
function, set this to “ON”.
Figure 4-32 DC filter
to switch between
OFF and ON
Press Hz
to edit
Press or
Press Hz to save
and exit
or press Esc
to exit without saving
• When DC filter is enabled, the measurement speed may decrease
during DC voltage measurement.
• During AC or Hz measurement (on primary or secondary display), DC
filter will be automatically disabled.
To Next Page
Loading...
Need help?
General
