ahlmann AL 65 - Changing the Oil in the Rear Axle; Slow Loader 20 Km;H

8-8 K65C/K75C/K95C 8-8 K65C/K75C/K95C
2
1
2
1
2
1
2
1
(3) Unscrew the plug from the
distribution gear (8-12/arrow).
NOTE
- The oil level must reach the plug
bore.
- Collect any oil that escapes.
(4) Screw in the plug again.
8.2.9 Changing the oil in the
rear axle
8.2.9.1Slow loader
» 20 km/h «
(1) Place a sufficiently large oil
drain pan underneath the axle.
(2) Unscrew the plugs from the axle
arch (8-13/1 and 8-13/2) and the
intermediate gear (8-14/1 and
8-14/2) and let the oil drain out.
CAUTION
Waste oil must be disposed of in
such a way that it will not cause
pollution!
(3) Screw in the plugs for the axle
arch (8-13/2) and the intermediate
gear (8-14/2) again.
Figure 8-13
Figure 8-14
Figure 8-12
(3) Unscrew the plug from the
distribution gear (8-12/arrow).
NOTE
- The oil level must reach the plug
bore.
- Collect any oil that escapes.
(4) Screw in the plug again.
8.2.9 Changing the oil in the
rear axle
8.2.9.1Slow loader
» 20 km/h «
(1) Place a sufficiently large oil
drain pan underneath the axle.
(2) Unscrew the plugs from the axle
arch (8-13/1 and 8-13/2) and the
intermediate gear (8-14/1 and
8-14/2) and let the oil drain out.
CAUTION
Waste oil must be disposed of in
such a way that it will not cause
pollution!
(3) Screw in the plugs for the axle
arch (8-13/2) and the intermediate
gear (8-14/2) again.
Figure 8-13
Figure 8-14
Figure 8-12