ahlmann AL 65 - Notes Regarding Maintenance

K65C/K75C/K95C 8-1 K65C/K75C/K95C 8-1
8 Maintenance
8.1 Notes regarding
maintenance
DANGER
- The engine must be turned off.
- For work to be carried out under
the bucket arm:
- the bucket must be emptied or
the attachment must be re-
lieved,
- the bucket arm support (1-2/
arrow) must be inserted,
- the ball block valve for the
working and auxiliary hydrau-
lics (1-3/arrow) must be closed.
- For work to be carried out in the
area of the articulation joint, the
articulation safeguard must be
inserted (1-4/arrow).
- The loader must be secured
against rolling by applying the
parking brake (4-12/3) and by
setting the drive direction switch
(4-12/6) to position "0". In addi-
tion, wheel chocks must be placed
on both sides of one of the two
wheels of the front axle.
CAUTION
- Change the oil when the units are
luke warm.
- Check the oil level when the loader
is on level ground and when the
bucket arm is in its lowest position.
- Immediately replace damaged
filter inserts and gaskets.
- Clean pressure lubrication fittings
before lubricating.
8 Maintenance
8.1 Notes regarding
maintenance
DANGER
- The engine must be turned off.
- For work to be carried out under
the bucket arm:
- the bucket must be emptied or
the attachment must be re-
lieved,
- the bucket arm support (1-2/
arrow) must be inserted,
- the ball block valve for the
working and auxiliary hydrau-
lics (1-3/arrow) must be closed.
- For work to be carried out in the
area of the articulation joint, the
articulation safeguard must be
inserted (1-4/arrow).
- The loader must be secured
against rolling by applying the
parking brake (4-12/3) and by
setting the drive direction switch
(4-12/6) to position "0". In addi-
tion, wheel chocks must be placed
on both sides of one of the two
wheels of the front axle.
CAUTION
- Change the oil when the units are
luke warm.
- Check the oil level when the loader
is on level ground and when the
bucket arm is in its lowest position.
- Immediately replace damaged
filter inserts and gaskets.
- Clean pressure lubrication fittings
before lubricating.