ahlmann AL 65 - Checks before Start-Up; Starting up; Starting the Diesel Engine

K65C/K75C/K95C 5-1 K65C/K75C/K95C 5-1
5 Operation
5.1 Checks before start-up
- Engine oil level (see the ope-
rating instructions for the engine)
- Brake fluid level
- Hydraulic oil level
- Fuel level
- Tire pressure
- Profile depth
- Lighting system
- Seat position
- Ball block valve for the working
and auxiliary hydraulics (1-3/
arrow); open if necessary
»only if work is to be commenced«
- Bucket arm support (1-2/arrow);
remove if necessary
- Articulation safeguard (1-4/
arrow); remove if necessary
- General state of the loader, e.g.
check for leaks
5.2 Starting up
5.2.1 Starting the diesel
engine
(1) Pull the lever for the parking
brake (4-12/3).
(2) Set the drive switch (4-12/6)
to position "0" (starter interlock!).
(3) Insert the battery main switch
(4-11/3).
(4) Insert the ignition key into the
starter switch (4-13/19) and turn the
key clockwise to position "I" (5-1).
NOTE
- The control lamp for battery char-
ging, the parking brake indicator
lamp and the engine oil pressure
lamp light up. The fuel gauge, the
engine oil temperature gauge and
the operating hour meter function.
- Start the engine in position "0" of
the drive switch (4-12/6).
Figure 5-1
5 Operation
5.1 Checks before start-up
- Engine oil level (see the ope-
rating instructions for the engine)
- Brake fluid level
- Hydraulic oil level
- Fuel level
- Tire pressure
- Profile depth
- Lighting system
- Seat position
- Ball block valve for the working
and auxiliary hydraulics (1-3/
arrow); open if necessary
»only if work is to be commenced«
- Bucket arm support (1-2/arrow);
remove if necessary
- Articulation safeguard (1-4/
arrow); remove if necessary
- General state of the loader, e.g.
check for leaks
5.2 Starting up
5.2.1 Starting the diesel
engine
(1) Pull the lever for the parking
brake (4-12/3).
(2) Set the drive switch (4-12/6)
to position "0" (starter interlock!).
(3) Insert the battery main switch
(4-11/3).
(4) Insert the ignition key into the
starter switch (4-13/19) and turn the
key clockwise to position "I" (5-1).
NOTE
- The control lamp for battery char-
ging, the parking brake indicator
lamp and the engine oil pressure
lamp light up. The fuel gauge, the
engine oil temperature gauge and
the operating hour meter function.
- Start the engine in position "0" of
the drive switch (4-12/6).
Figure 5-1