ahlmann AL 65 - Page 67

K65C/K75C/K95C 4-7 K65C/K75C/K95C 4-7
3
2
1
3
2
1
Lifting height restriction
(option)
A device allowing the maximum
lifting height to be restricted is in-
stalled at the junction of the bucket
unit and the center support.
Adjustment:
(1) Lift the bucket arm to the
desired height.
(2) Shut down the engine and
close the ball block valves for the
working and auxiliary hydraulics
(1-3/arrow).
(3) Loosen the hex screw (size
10) (4-8/3) of the shift gate and turn
the shift gate (4-8/2) towards the
roller switch (4-8/1) until it switches
audibly.
(4) Tighten the hex screw of the
shift gate.
DANGER
Perform a function check before
starting work with the lifting height
restriction. Observe the lifting height
restriction from the driver's seat
during work.
Equipment
Driver's seat
The driver's seat has a hydraulic
suspension and is provided with a
pelvis safety belt and arm rests
(height-adjustable). The weight
compensation, the horizontal and
height position as well as the back-
rest and the seat inclination can be
adjusted.
Operator's cabin
Standard ROPS design with ECC
conformity certificate. Comfortable
entry and exit from both sides, lock-
able doors, front and rear wind-
shield wipers/washers, sun visor,
good all-round vision, multi-speed
heating/ventilation system.
Figure 4-8
Lifting height restriction
(option)
A device allowing the maximum
lifting height to be restricted is in-
stalled at the junction of the bucket
unit and the center support.
Adjustment:
(1) Lift the bucket arm to the
desired height.
(2) Shut down the engine and
close the ball block valves for the
working and auxiliary hydraulics
(1-3/arrow).
(3) Loosen the hex screw (size
10) (4-8/3) of the shift gate and turn
the shift gate (4-8/2) towards the
roller switch (4-8/1) until it switches
audibly.
(4) Tighten the hex screw of the
shift gate.
DANGER
Perform a function check before
starting work with the lifting height
restriction. Observe the lifting height
restriction from the driver's seat
during work.
Equipment
Driver's seat
The driver's seat has a hydraulic
suspension and is provided with a
pelvis safety belt and arm rests
(height-adjustable). The weight
compensation, the horizontal and
height position as well as the back-
rest and the seat inclination can be
adjusted.
Operator's cabin
Standard ROPS design with ECC
conformity certificate. Comfortable
entry and exit from both sides, lock-
able doors, front and rear wind-
shield wipers/washers, sun visor,
good all-round vision, multi-speed
heating/ventilation system.
Figure 4-8