defined.
● URL To Trigger All Floors: enter the Akuvox URL for triggering all floors.
● URL To Close All Floors: enter the Akuvox URL used for closing all floors.
23.6.ZKT Lift Controller
You are required to configure ZKteco lift controller before you can connect the
door phone to the lift controller. You can navigate to Lift Control > Akuvox EC32
& ZKT Advance Setting.
Parameter Set-up:
● Server IP: enter the IP address of the Akuvox EC32 controller server.
● Port: enter the port of Akuvox EC32 controller server.
● Timeout (Sec): enter the lift controller timeout. For example, if you set the
timeout as “30 seconds” have to press the lift button corresponding to the
floor you are going to within 30 seconds, otherwise, the button will be locked
again, and you have to go out of the lift and do it all over again.
23.7.Chiyu Lift Controller
You need to select Chiyu lift controller to integrate with Chiyu lift controller. You
can navigate to Intercom > Lift Control.
To Next Page
Loading...
Need help?
General
