9.5.NAT Setting
NAT (Network Address Translation) allows hosts in an organization’s private
intranet to transparently connect to hosts in the public domain. There is no need
for internal hosts to have registered Internet addresses. It is a way to translate
the internal private network IP address into a legal network IP address
technology. To do this configuration on web Account > Advance > NAT
interface.
Parameter Set-up:
● UDP Keep Alive Messages: if enabled, the device will send out the
message to the SIP server so that the SIP server will recognize if the device
is in online status.
● UDP Alive Msg Interval: set the message sending time interval from 5-60
seconds, the default is 30 seconds.
● RPort: enable the Rport when the SIP server is in WAN (Wide Area
Network).
9.6.SNMP Setting
SNMP (Simple Network Management Protocol) is an Internet-standard protocol
for managing devices on IP networks. SNMP is widely used in the network
management system to monitor network-attached devices for conditions that may
draw network administrative attention. SNMP exposes management data in the
form of variables on the managed systems, which describe the system
configuration. These variables can then be queried by managing applications.
These variables accessible via SNMP are organized in hierarchies, which are
described by Management Information Bases (MIBs). To do the configuration on
the web Network > Advanced > SNMP interface.
To Next Page
Loading...
Need help?
General
