7.4.LED Setting on Card Reader Area
You can enable or disable the LED lighting on the card reader area as needed on
the web interface. Meanwhile, If you do not want to have the LED light on the
card reader area to stay on, you can also set the timing for the exact time span
during which the LED light can be disabled in order to reduce the electrical power
consumption. Path: Intercom > LED Setting > LED Control.
Parameters Set-up:
● Card LED Enabled: tick the check box if want to enable the card reader LED
lighting and vice versa.
● Time (H): enter the time span for the LED lighting to be valid, e.g. if the time
span is set from 8-0 (Sart time- End time) it means LED light will stay on
during the time span from 8:00 am to 12:00 pm during one day (24 hours).
To Next Page
Loading...
