TROUBLESHOOTING
Problem
System has locked up.
The camera’s signal
status icon shows no
bars.
Possible Solution
Turn off the monitor and restart. If power button does not
respond, use a pin to press the Reset button located on
the side of the monitor.
Make sure the camera is plugged in and the red LED is
on; see page 13.
Make sure the camera is paired to the correct channel;
see page 12.
Re-pair the camera to the monitor.
Move the camera closer to the monitor; it might be out of
range or flip the antenna of the monitor and/or camera to
obtain best possible reception.
To Next Page
Loading...
