Alcatel-Lucent 7210 SAS M - Page 226

Command Hierarchies
Page 226 7210 SAS M, X Basic System Configuration Guide
System Alarm Contact Commands
config
— system
— alarm-contact-input alarm-contact-input-id
— [no] alarm-output-severity [critical | major| none] (for SAS M only)
— [no] alarm-output-severity [critical | major | minor | none] (for SAS Xonly)
— [no] clear-alarm-msg {alarm-msg-txt}
— description description-string
— normal-state [open | closed]
— [no] shutdown
— [no] trigger-alarm-msg {alarm-msg-txt}
System Synchronization Commands
config
—system
— sync-if-timing
— abort
— begin
— commit
— ref-order first second
—no ref-order
— ref1
— ql-override {prs | stu | st2 | tnc | st3e | st3 | prc | ssua | ssub | sec | eec1 | eec2}
—no ql-override
— [no] shutdown
— source-port port-id
—no source-port
— ref2
— ql-override {prs | stu | st2 | tnc | st3e | st3 | prc | ssua | ssub | sec | eec1 | eec2}
—no ql-override
— [no] shutdown
— source-port port-id
—no source-port
— [no] ql-selection
— [no] revert
LLDP System Commands
configure
— system
— lldp
— message-fast-tx time
—no message-fast-tx
— message-fast-tx-init count
—no message-fast-tx-init
— notification-interval time
—no notification-interval
— reinit-delay time
—no reinit-delay
— [no] shutdown
— tx-credit-max count
—no tx-credit-max